HummingBird Addendum Instructions
  1. Your HummingBird helicopter comes with landing gear that is unequal in length, this is normal and required for straight take off. Do not change the length of the landing struts otherwise the HummingBird will pull hard to the right at lift off.

  2. JR radio equipment: On JR radios, the throttle channel needs to be reversed.

  3. JR receivers: The connectors on the HummingBoard are square in design. When using an original JR receiver, two edges need to be shaved (chamfered) to fit into the receiver.


  4. When using radio equipment that is different than shown in the manual, you will need to reposition the receiver and the HummingBoard to make all the connections.

  5. HummingBoard: It is normal on some radios to have the LED on the board appear as solid green at below half stick and then change to solid red from half stick to full power. This is normal operation.

Updated: February 2003