page 1 | page 2 | page 3 | page 4 | customer support

 Hawk Sport Quick Build Guide page 2

Assemble the fuel bung with the vent/muffler pressure tube (longer one) bent upward to the inside top of the fuel tank and the carburetor line pointing to the inside middle of the fuel tank. Secure with the screw and tie wrap.

Install the pressure nipple to the top of the muffler and the 4mm plug screw to the bottom (we recommend that you use a high temperature silicone or thread lock to seal these items). Bolt the muffler to the engine and run fuel tubing from the carburetor and muffler pressure outlets of the fuel tank to the carburetor inlet and the muffler pressure nipples.
 

Install the flybar, flybar control arms, flybar weights and flybar paddles into the rotor head seesaw assembly as per the detailed instructions. Be sure to balance and alignment of the flybar paddles and flybar control arms. Install the completed rotor head to thr top of the mainshaft.
 

Attach the front struts to the bottom of the mainframes and insert the metal skids. Slide the back struts onto the skids and secure to the frames.NOTE: the rear of the skids should protrude about 30mm. Secure the skids into position with the four allen screws provided.
 

Carefully cut out the windshield area from the canopy with a sharp hobby knife. Trial fit the canopy and mark the location of the front lower mount, drill the two required holes and attach to the inside of the canopy with the screws and washers provided.

Mount the front of the canopy and mark the location of the top rear mounts. Drill the 1/4 “ holes and insert the grommets. Mount the canopy onto the frame. Cut out the windshield along the marked lines and install onto the canopy with the six small screws supplied. Cut out the decals for the canopy from the decal sheet and attach to the canopy.

page 1 | page 2 | page 3 | page 4 | customer support