This Century HAWK SPORT kit comes in a QUICK BUILD format that has most of the major systems already assembled into sub-assemblies. These are packed seperately into their specific bags that include the other items that may be needed to attach them to the other subassemblies or to attach other items to them.. NOTE: We suggest that you refer to the more detailed instructions at the back of the manual if you require more comprehensive instructions or ever need to repair an assembly after a mishap.

Mount the clutch bell, clutch and fan to the engine using thread lock. Remove the stock throttle arm and attach the longer one supplied (be sure to use thread lock). Also using thread lock, mount the engine to the engine mounts in the lower frame assembly. Open the backside of the lower fan shroud and re-install over the engines heat sink. Note: flanged area to the top.

Attach the rear upper canopy mounts to the upper frame assembly. Slide the clutch assembly / lower frame into position from the rear (see large picture on the left) and attach the lower frame assembly to the upper frame assembly using thread lock on the four upper bolts.

Inserting the servos from the back of the left side of the servo tray assembly, attach the lower servo with the output towards the front and the upper servo with the output towards the rear. Attach the radio switch into the loction provide on the right side. Slip the gyro onto the rear of the tray and attach with double sided gyro tape between the two servos on the left and the switch on the right.

Attach servo in the middle of the top servo tray with the servo output to the front. Attach another on each side with the servo outputs to the rear. Attach the completed servo frame assembly to the front of the completed mainframe assembly using the screws at the top and middle (shorter screws) and the bolts through the fan shroud at the bottom.